LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Optima SX Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 73 (Active Hydraulic Boost (AHB) System (HEV)) >> Pressure Source Unit >> Repair Procedures >> Installation >> Pressure Sensor Calibration

Pressure Sensor Calibration

WARNING: This page is about a different variant/trim than selected.

The pressure sensor mounted within the PSU calculates the pressure according to initial zeroing. Therefore, initial zeroing adjustment is required when installed for the first time. After replacing the PSU (you cannot change only the sensor), the calibration must be performed.

scientia non olet · About LEMON Manuals