LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Optima SX Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 73 (Active Hydraulic Boost (AHB) System (HEV)) >> Pressure Source Unit >> Repair Procedures >> Installation >> Notes

Repair Procedures: Installation: Notes

WARNING: This page is about a different variant/trim than selected.
  1. Installation is the reverse of removal.
  2. Check the brake pedal operation.
  3. After filling the brake fluid in the reservoir, perform the air bleed. (Refer to AHB Brake System Bleeding Procedure . )
  4. Conduct calibration after removing the brake pedal assembly. (Refer to Brake pedal sensor Calibration . )
  5. Tighten the PSU bracket bolts and brake tube to the specified torque.
  6. Conduct calibration after removing or installing the PSU.
scientia non olet · About LEMON Manuals