LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Optima SX Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 73 (Active Hydraulic Boost (AHB) System (HEV)) >> Brake Pedal >> Repair Procedures >> Stop lamp switch clearance adjustment >> Removal

Stop lamp switch clearance adjustment: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition switch OFF and disconnect the negative (-) battery cable.
  2. Remove the crash pad lower panel and reinforcing panel. (Refer to Crash Pad )
  3. Remove the shower duct (A).
    Fig 1: Locating Shower Duct
    G11816788Courtesy of KIA MOTORS AMERICA, INC.
  4. Pull down steering column shaft after removing bolts and nuts. (Refer to Steering Column & Shaft .)
  5. Disconnect the stop lamp switch connector (A) and the brake pedal stroke sensor connector (B).
    Fig 2: Locating Stop Lamp Switch Connector & Brake Pedal Stroke Sensor Connector
    G11816789Courtesy of KIA MOTORS AMERICA, INC.
  6. Pull the locking plate (A) as indicated by the arrow.
    Fig 3: Pulling Locking Plate
    G11816790Courtesy of KIA MOTORS AMERICA, INC.
  7. Turn stop lamp switch 45° counterclockwise and remove it.
Fig 4: Removing Stop Lamp Switch
G11816791Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About LEMON Manuals