LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Optima SX Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 73 (Active Hydraulic Boost (AHB) System (HEV)) >> Brake Pedal >> Repair Procedures >> Stop lamp switch clearance adjustment >> Installation

Stop lamp switch clearance adjustment: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Hold the brake pedal arm and insert the stop lamp switch fully.
    Fig 1: Inserting Stop Lamp Switch
    G11816792Courtesy of KIA MOTORS AMERICA, INC.
  2. After inserting, turn the stop lamp switch 45° clockwise; then, finish to assemble it by pushing the locking plate.
  3. Check the gap between stop lamp switch and bracket.

    Stop lamp clearance:  1.0 ~ 2.0 mm (0.04 ~ 0.08 in.)

    Fig 2: Checking Gap Between Stop Lamp Switch And Bracket
    G11816793Courtesy of KIA MOTORS AMERICA, INC.
    NOTE: If the gap between stop lamp switch and bracket is not 1.0 ~ 2.0mm(0.04~ 0.08in), perform above procedure again.
  4. Connect the stop lamp switch connector.
  5. Following installation is the reverse of removal.
scientia non olet · About LEMON Manuals