LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Optima SX Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Exterior Body Panels (HEV)) >> Trunk Lid >> Repair Procedures >> Replacement >> Trunk Lid Assembly Replacement

Trunk Lid Assembly Replacement

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • When removing and installing the trunk lid, an assistant is necessary.
  • Wear gloves to protect hands from injury.
  1. Loosen the trunk inside handle (A) mounting screws.
    Fig 1: Loosening Trunk Inside Handle Mounting Screws
    G11816907Courtesy of KIA MOTORS AMERICA, INC.
  2. Detach the clips, then remove the trunk lid trim (A).
    Fig 2: Detaching Trunk Lid Trim Clips
    G11816908Courtesy of KIA MOTORS AMERICA, INC.
  3. Disconnect wiring (B) and connectors.
  4. After loosening the mounting bolts, then remove the trunk lid (A).

    Tightening torque: 

    6.9~8.8 N.m (0.7~0.9 kgf.m, 5.1~6.5 lb-ft)

    Fig 3: Removing Wiring, Trunk Lid And Mounting Bolts
    G11816909Courtesy of KIA MOTORS AMERICA, INC.
  5. Installation is the reverse of removal.
    NOTE:
    • Replace any damaged clips.
scientia non olet · About LEMON Manuals