Door Module Replacement

WARNING: This page is about a different variant/trim than selected.

Remove the following parts:
- Rear door trim
- Window glass
- Rear door DIV channel
- Rear door fixed glass
After loosening the rear door module mounting bolts, then remove the rear door module (A).
Tightening torque:

6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

Fig 1: Loosening Rear Door Module Mounting Bolts
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the connectors, then remove the wiring harness (A).

Fig 2: Rear Door Wiring Harness
Courtesy of KIA MOTORS AMERICA, INC.
Installation is the reverse of removal.
NOTE:
- The area of whole parts should be applied with sufficient grease.
- Make sure connectors are connected properly and each rod is connected securely.
- Make sure the door locks/unlocks and opens/closes properly.