Inspect Glass Alignment

WARNING: This page is about a different variant/trim than selected.

Check for abnormal noise or bending during operation.
With the sunroof fully closed, check for water leakage.
The roof panel (A) should be even with the movable glass (B) weatherstrip, to within the standard value "E" all the way around. If not, make the following adjustment.
Tightening torque:

Standard value "E" [mm(in.)]
1. Front edge: 1.2 mm (0.0472 in.)
2. Rear edge: 1.0 mm (0.0394 in.)
Fig 1: Locating Roof Panel, Movable Glass And Standard Value
Courtesy of KIA MOTORS AMERICA, INC.
If the position is not as specified, lightly loosen the glass adjusting screws (A) to adjust the glass height and tighten it.
CAUTION:
- Do not damage the screws.
Fig 2: Loosening Glass Adjusting Screws
Courtesy of KIA MOTORS AMERICA, INC.