Hood Latch Replacement

WARNING: This page is about a different variant/trim than selected.

After loosening the mounting clips and bolts, then remove the radiator upper cover (A).

Fig 1: Loosening Radiator Upper Cover Mounting Clips And Bolts
Courtesy of KIA MOTORS AMERICA, INC.
Detach the clips, then remove hood latch cover (A).

Fig 2: Detaching Hood Latch Cover Clips
Courtesy of KIA MOTORS AMERICA, INC.
Remove the hood latch (A) mounting bolts.
Tightening torque:

7.8 ~ 11.8N.m (0.8 ~ 1.2kgf.m, 5.8 ~ 8.7 lb-ft)

Fig 3: Removing Hood Latch Mounting Bolts
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the hood latch cable (A) and remove the hood latch (B).

Fig 4: Disconnecting Hood Latch And Hood Latch Cable
Courtesy of KIA MOTORS AMERICA, INC.
Installation is the reverse of removal.
NOTE:
- Make sure the hood latch release cable is connected properly.
- Make sure the hood locks/unlocks and opens/closes properly.
- Adjust the latch alignment.