LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Optima SX Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Exterior Body Panels (HEV)) >> Hood >> Repair Procedures >> Replacement >> Hood Assembly Replacement

Hood Assembly Replacement

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • When removing and installing the hood, an assistant is necessary.
  • Be careful not to damage the hood and body.
  • When removing the clips, use a clip remover.
  1. Using a screwdriver, lift the socket clips (A) up slightly on both ends of the lifter (B).
    Fig 1: Locating Socket Clip And Lifter
    G11816895Courtesy of KIA MOTORS AMERICA, INC.
  2. After loosening the hood hinge (A) mounting bolts, remove the hood panel (B).

    Tightening torque: 

    21.6~26.5 N.m (2.2~2.7 kgf.m, 15.9~19.5 lb-ft)

    Fig 2: Locating Hood Panel And Hood Hinge
    G11816896Courtesy of KIA MOTORS AMERICA, INC.
  3. Installation is the reverse of removal.
    NOTE:
    • Make sure the hood locks/unlocks and opens/closes properly.
    • Adjust the hood alignment.
scientia non olet · About LEMON Manuals