LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Optima SX Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Exterior Body Panels (HEV)) >> Front Door >> Repair Procedures >> Replacements >> Glass Replacement

Glass Replacement

WARNING: This page is about a different variant/trim than selected.
  1. Remove the front door trim.
  2. Disconnect the speaker connector (B).
  3. After loosening the mounting screws, then remove the speaker (A).
    Fig 1: Loosening Speaker Mounting Screws
    G11816922Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the front door belt inside weatherstrip (A).
    Fig 2: Locating Front Door Weatherstrip
    G11816923Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the glass mounting hole plug (B).
    CAUTION:
    • Use the door switch to align the mounting hole/bolt with the hole in the door.
    • If unable to operate the window motor, remove the motor and align the hole by hand.
    • Be careful not to drop the glass and/or scratch the glass surface.
  6. Carefully adjust the glass (A) until you can see the bolts, then loosen them. Separate the glass from the glass run and carefully pull the glass out

    through the window slot.

    Tightening torque: 

    3.9 ~ 2.9 N.m (0.4 ~ 1.2 kgf.m, 11.8 ~ 8.7 lb-ft)

    Fig 3: Adjusting Glass
    G11816924Courtesy of KIA MOTORS AMERICA, INC.
  7. Installation is the reverse of removal.
    NOTE:
    • Roll the glass up and down to see if it moves freely without binding.
    • Adjust glass position as needed.
    • Make sure the door lock and opens properly.
    • Replace any damaged clips.
scientia non olet · About LEMON Manuals