Door Module Assembly Replacement

WARNING: This page is about a different variant/trim than selected.

Remove the following parts:
- Front door trim
- Window glass
- Outside handle
Loosen the mounting bolt (A).

Fig 1: Removing Door Module Assembly Mounting Bolt
Courtesy of KIA MOTORS AMERICA, INC.
After loosening the door module mounting bolts, then remove the front door module (A).
Tightening torque:

6.9~10.8 N.m (0.7~1.1 kgf.m, 5.1~8.0 lb-ft)

Fig 2: Loosening Door Module Mounting Bolts
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the outside handle connector (A) and outside handle rod (B).

Fig 3: Disconnecting Outside Handle Connector And Outside Handle Rod
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the connectors and door module wiring harness (A).

Fig 4: Disconnecting Door Module Wiring Harness And Connectors
Courtesy of KIA MOTORS AMERICA, INC.
Installation is the reverse of removal.
NOTE:
- The area of whole parts should be applied with sufficient grease.
- Make sure connectors are connected properly and each rod is connected securely.
- Make sure the door locks/unlocks and opens/closes properly.