Door Latch Replacement

WARNING: This page is about a different variant/trim than selected.

Remove the following items:
- Front door trim
- Window glass
- Outside handle
Loosen the mounting bolt (A).

Fig 1: Loosening Door Latch Mounting Bolt
Courtesy of KIA MOTORS AMERICA, INC.
After loosening the door module mounting bolts, then remove the front door module (A).
Tightening torque:

6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

Fig 2: Loosening Front Door Module Mounting Bolts
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the outside handle connector (A).

Fig 3: Locating Outside Handle Connector
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the connector (C) and rod (B).
Remove the rear door latch (A).

Fig 4: Disconnecting Rear Door Latch, Connector And Rod
Courtesy of KIA MOTORS AMERICA, INC.
Installation is the reverse of removal.
NOTE:
- Make sure the connector is connected properly.
- Make sure the door locks/unlocks and opens/closes properly.
- Replace any damaged clips.