Air Bleeding Tool Installation Procedure

WARNING: This page is about a different variant/trim than selected.

CAUTION: To ensure technician safety and prevent damage to the brake fluid reservoir; adjust the air pressure on the air bleeding tool (09580-3D100) gauge to the standard value: 0.3 ~ 0.5MPa (43.5 ~ 72.5psi) before installing.

Before installing the air bleeding tool (09580-3D100) on the vehicle, close the air shut-off valve (A) to adjust the pressure gauge to the standard value: 0.3 ~ 0.5MPa (43.5 ~ 72.5psi).

Fig 1: Locating Air Shut-Off Valve And Plug
Courtesy of KIA MOTORS AMERICA, INC.

CAUTION: To prevent injury to technician, make sure that the plug (B) is installed correctly.
After connecting the air hose to air bleeding tool, open the air shut-off valve (A) and adjust the pressure gauge (B) to the standard value: 0.3 ~ 0.5MPa (43.5 ~ 72.5psi).
Standard pressure value: 0.3 ~ 0.5MPa (43.5 ~ 72.5psi)

Fig 2: Locating Pressure Gauge And Air Shut-Off Valve
Courtesy of KIA MOTORS AMERICA, INC.
Close the air shut-off valve (A) and then remove the plug (B).

Fig 3: Locating Air Shut-Off Valve And Plug
Courtesy of KIA MOTORS AMERICA, INC.

CAUTION: To prevent injury to technician, make sure that the air shut-off valve is closed, then remove the plug.
Remove the brake reservoir cap.
Install the cap (A) of air bleeding tool (0k585-E8100) on the reservoir.

Fig 4: Installing Cap Of Air Bleeding Tool (0K585-E8100) On Reservoir
Courtesy of KIA MOTORS AMERICA, INC.
Make sure the check valve (A) is closed and connect air bleeding tool (09580-3D100) (A) to the adapter (B).

Fig 5: Connecting Air Bleeding Tool (09580-3D100) To Adapter

Courtesy of KIA MOTORS AMERICA, INC.