Toe adjustment
WARNING: This page is about a different variant/trim than selected.
- Loosen the tie rod end lock nut.
- Remove the bellows clip to prevent the bellows from being twisted.
- Adjust the toe by screwing or unscrewing the tie rod. Toe adjustment should be made by turning the right and left tie rods by the same amount.
Toe-in
Total: 0.16° ± 0.2°
Individual: 0.08° ± 0.1°
- When completing the toe adjustment, install the bellows clip and tighten the tie rod end lock nut to specified torque.
Tightening torque:
50 ~ 55 N.m (5.0 ~ 5.5 kgf.m, 36 ~ 40 lb-ft)
- Compensate the steering angle sensor after adjusting the wheel alignment.
(Refer to STEERING COLUMN-SHAFT )