LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Optima SX Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 43 (Engine Cooling System (HEV)) >> Active Air Flap (AAF) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the front bumper. (Refer to "Front Bumper ".)
  2. Remove the headlamps. (Refer to "Head Lamps ".)
  3. Remove the air guards (A).
    Fig 1: Removing Air Guards
    G11815454Courtesy of KIA MOTORS AMERICA, INC.
  4. Unfasten the 2 bolts (A) and 2 fasteners (B).
    Fig 2: Locating Front Bumper Bolts And Fasteners
    G11815455Courtesy of KIA MOTORS AMERICA, INC.
  5. Disconnect the AAF (Active air flap) actuator connector (A).
    Fig 3: Locating Active Air Flap Actuator Connector
    G11815456Courtesy of KIA MOTORS AMERICA, INC.
  6. Remove the AAF (Active air flap) assembly (A).
    Fig 4: Active Air Flap Assembly
    G11815457Courtesy of KIA MOTORS AMERICA, INC.
  7. Installation is the reverse of removal.
scientia non olet · About LEMON Manuals