Repair Procedures: Disassembly

WARNING: This page is about a different variant/trim than selected.

Separate the duct (A) from the AAF (Active air flap) (B).

Fig 1: Separating Duct From Active Air Flap
Courtesy of KIA MOTORS AMERICA, INC.
Remove the actuator cover (A) from the housing (B).

Fig 2: Removing Actuator Cover From Housing
Courtesy of KIA MOTORS AMERICA, INC.
Remove the actuator (A) from the housing (B).

Fig 3: Removing Actuator From Housing
Courtesy of KIA MOTORS AMERICA, INC.
Remove the link (A) and flaps (B) from the housing (C).

Fig 4: Removing Link And Flaps From Housing
Courtesy of KIA MOTORS AMERICA, INC.
Assembly is the reverse of disassembly.
NOTE: When assembling, the link and flaps should be in full open position.