Package Tray Trim Replacement

WARNING: This page is about a different variant/trim than selected.

CAUTION:

Put on gloves to protect your hands.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.

Remove the rear seat assembly.
(Refer to "Rear Seat ".)
After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).
LH, RH

Tightening torque:

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

Fig 1: Removing Rear Seat Belt Lower Anchor Mounting Bolt
Courtesy of KIA MOTORS AMERICA, INC.

Center

Tightening torque:

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

Fig 2: Removing Rear Seat Belt Lower Anchor Mounting Bolt (Center)
Courtesy of KIA MOTORS AMERICA, INC.
Using a screwdriver or remover, remove the rear pillar trim (A).

Fig 3: Removing Rear Pillar Trim
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the connector (A).

Fig 4: Disconnecting Connector
Courtesy of KIA MOTORS AMERICA, INC.
Using a screwdriver or remover, remove the rear seat belt cover (B).
After loosening the mounting screws, then remove the package tray trim (A).

Fig 5: Removing Package Tray Trim
Courtesy of KIA MOTORS AMERICA, INC.
Installation is the reverse of removal.
NOTE:
- Replace any damaged clips.
- Make sure the connector is connected properly.