Glove Box Replacement

WARNING: This page is about a different variant/trim than selected.

CAUTION:

When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.

Using a screwdriver or remover, remove the crash pad side cover (A).

Fig 1: Removing Crash Pad Side Cover
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the guide (B) from the glove box (A).

Fig 2: Disconnecting Guide From Glove Box
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the lift (A) from the glove box (B).

Fig 3: Disconnecting Lift From Glove Box
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the pin (A) and then remove the glove box (B).

Fig 4: Removing Glove Box
Courtesy of KIA MOTORS AMERICA, INC.
After loosening the mounting screw, then remove the passenger's under cover (A).

Fig 5: Removing Passenger Under Cover
Courtesy of KIA MOTORS AMERICA, INC.
After loosening the mounting screws, then remove the glove box housing (A).

Fig 6: Removing Glove Box Housing
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the connectors (A).
LH

Fig 7: Disconnecting Connectors (LH)
Courtesy of KIA MOTORS AMERICA, INC.

RH

Fig 8: Disconnecting Connectors (RH)
Courtesy of KIA MOTORS AMERICA, INC.
Installation is the reverse of removal.
NOTE:
- Make sure the connectors are connected in properly.
- Replace any damaged clips.