Floor Console Replacement

WARNING: This page is about a different variant/trim than selected.

CAUTION:

When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.

To remove the gear knob (A) pull up using moderate force. Then using a screwdriver or remover tool, remove the gear boot (B).

Fig 1: Removing Gear Knob & Boot
Courtesy of KIA MOTORS AMERICA, INC.
Using a screwdriver or remover, remove the floor console upper cover (A).

Fig 2: Removing Floor Console Upper Cover
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the connectors (A).

Fig 3: Disconnecting Connectors
Courtesy of KIA MOTORS AMERICA, INC.
Remove the console tray mat (A).

Fig 4: Removing Console Tray Mat
Courtesy of KIA MOTORS AMERICA, INC.
Using a screwdriver or remover, remove the floor console extension cover (A).

Fig 5: Removing Floor Console Extension Cover
Courtesy of KIA MOTORS AMERICA, INC.
After loosening the mounting screws and bolts, then remove the floor console assembly (A).

Fig 6: Removing Floor Console Assembly
Courtesy of KIA MOTORS AMERICA, INC.
Installation is the reverse of removal.
NOTE:
- Make sure the connectors are connected in properly.
- Replace any damaged clips.