LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Optima SX Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 37 (Fuel Delivery System (HEV)) >> Delivery Pipe >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
  2. Release the residual pressure in fuel line. (Refer to RELEASE RESIDUAL PRESSURE IN FUEL LINE .)
  3. Disconnect the injector connector (A).
  4. Remove the wiring harness bracket mounting bolt (B).
  5. Remove the mounting nut, and then disconnect the fuel feed tube (C).
  6. Remove the mounting bolt (D), and then remove the delivery pipe & injector assembly from the engine.
Fig 1: Injector Connector (A), Wiring Harness Bracket Mounting Bolt (B), Fuel Feed Tube (C), And Mounting Bolt (D) (1 Of 2)
G11815830Courtesy of KIA MOTORS AMERICA, INC.
Fig 2: Delivery Pipe And Injector Assembly (2 Of 2)
G11815831Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About LEMON Manuals