Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.

Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
Disconnect the accelerator position sensor connector (A).

Fig 1: Accelerator Position Sensor Connector
Courtesy of KIA MOTORS AMERICA, INC.
Remove the mounting nuts (B) and bolt (C), and then remove the accelerator pedal module.

Fig 2: Accelerator Pedal Module Mounting Nuts (1 Of 2)

Courtesy of KIA MOTORS AMERICA, INC.

Fig 3: Accelerator Pedal Module Mounting Bolt (2 Of 2)

Courtesy of KIA MOTORS AMERICA, INC.