Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.

Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
Disconnect the crankshaft position sensor connector (A).

Fig 1: Locating Crankshaft Position Sensor Connector
Courtesy of KIA MOTORS AMERICA, INC.
Remove the protector (A).

Fig 2: Removing Protector
Courtesy of KIA MOTORS AMERICA, INC.
Remove the mounting bolt (A), and then remove the crankshaft position sensor.

Fig 3: Locating Crankshaft Position Sensor Mounting Bolt

Courtesy of KIA MOTORS AMERICA, INC.