LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Optima SX Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 36 (Engine Control System (HEV)) >> Canister Close Valve (CCV) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
  2. Lift the vehicle.
  3. Disconnect the canister close valve connector (A).
  4. Disconnect the ventilation hose (B) from the fuel tank air filter and canister close valve.
  5. Remove the fuel tank air filter assembly after removing bolts (C).
    Fig 1: Locating Canister Close Valve Connector, Ventilation Hose And Bolts
    G11815801Courtesy of KIA MOTORS AMERICA, INC.
  6. Release the lever (A), and then separate the canister close valve (B) from the fuel tank air filter (C) after rotating it in the direction of the arrow in the figure.
Fig 2: Releasing Canister Close Valve Lever
G11815802Courtesy of KIA MOTORS AMERICA, INC.
Fig 3: Canister Close Valve And Fuel Tank Air Filter
G11815803Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About LEMON Manuals