Rear Combination Lamp (Inside)

WARNING: This page is about a different variant/trim than selected.

Disconnect the negative (-) battery terminal.
Remove the trunk trim.
(Refer to Trunk Trim . )
If the tail lamp bulb should be only replaced without removing lamp assembly, replace the tail lamp bulb (A) after removing the trim cover in the trunk.

Fig 1: Removing Rear Combination Lamp (Inside)
Courtesy of KIA MOTORS AMERICA, INC.

NOTE: Back up lamp bulb is removed after removing the rear lamp assembly.
Remove the rear lamp assembly after removing the nuts and connector (A).

Fig 2: Removing Rear Lamp Assembly Nuts (1 Of 2)
Courtesy of KIA MOTORS AMERICA, INC.

Fig 3: Removing Rear Lamp Assembly Connector (2 Of 2)
Courtesy of KIA MOTORS AMERICA, INC.
Replace the back up lamp bulbs (A) by turning the sockets (B) counterclockwise.

Fig 4: Replacing Back Up Lamp Bulbs

G11818290

Courtesy of KIA MOTORS AMERICA, INC.