Repair Procedures: Installation

WARNING: This page is about a different variant/trim than selected.

Install in the reverse order of removal.
NOTE:
- Do not reuse the drain plug gasket.
- When tightening the clamp should be careful not to damage the hose.
- Install the clamp in the specified direction to prevent interference with surrounding components.
- Refill the automatic transaxle with fluid.
  (Refer to "Fluid ".)
- Refill the engine and transaxle cooling system with coolant.
  (Refer to Coolant . )
- Confirm the coolant leak or fluid leak from the hose connections part in state of engine start.