LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Optima SX Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Windshield Deicer System (HEV)) >> Windshield Deicer >> Repair Procedures >> Inspection

Repair Procedures: Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Remove the cowl top cover. (Refer to the wiper)
  2. Disconnect the windshield deicer connector (A) from the wiper motor linkage.
    Fig 1: Disconnecting Windshield Deicer Connector (A) From Wiper Motor Linkage
    G11818130Courtesy of KIA MOTORS AMERICA, INC.
  3. Check for continuity between the terminals of deicer lines.
    Fig 2: Checking Continuity Between Deicer Lines Terminals
    G11818131Courtesy of KIA MOTORS AMERICA, INC.
  4. Turn the ignition switch ON and the windshield deicer switch ON, then measure the voltage between the terminals of harness side deicer connector.

    OK:  approx: Battery voltage

    Fig 3: Measuring Voltage Between Harness Side Deicer Connector Terminals
    G11818132Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About LEMON Manuals