Repair Procedures: Replacement

Information 

• When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
• Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
• Take care not to bend or scratch the trim and panels.

1. Using a remover, remove the console garnish (A).
   Fig 1: Removing Console Garnish Using Remover

   Courtesy of KIA MOTORS AMERICA, INC.
2. Remove the glove box mounting hole cap (A).
   Fig 2: Removing Glove Box Mounting Hole Cap

   Courtesy of KIA MOTORS AMERICA, INC.
3. Using a remover, remove the crash pad side cover [RH] (A).
   Fig 3: Removing Crash Pad Side Cover (RH) Using Remover

   Courtesy of KIA MOTORS AMERICA, INC.
4. Remove the crash pad garnish [LH] (A).
   Fig 4: Removing Crash Pad Garnish (LH)

   Courtesy of KIA MOTORS AMERICA, INC.
5. Disconnect the stopper (B) from the glove box (A).
   Fig 5: Disconnecting Stopper From Glove Box

   Courtesy of KIA MOTORS AMERICA, INC.
6. Disconnect the air damper (A) from the glove box (B).
   Fig 6: Disconnecting Air Damper From Glove Box

   Courtesy of KIA MOTORS AMERICA, INC.
7. Disconnect the pins (A) and then remove the glove box (B).
   Fig 7: Removing Glove Box

   Courtesy of KIA MOTORS AMERICA, INC.
8. Remove the crash pad under cover [RH] (A).
   Fig 8: Removing Crash Pad Under Cover (RH)

   Courtesy of KIA MOTORS AMERICA, INC.
9. Separate the glove box housing (A) after loosening the mounting screws and bolts & nuts.
   Fig 9: Separating Glove Box Housing

   Courtesy of KIA MOTORS AMERICA, INC.
10. Disconnect the glove box lamp connector (A) and glove box housing (B).
    Fig 10: Disconnecting Glove Box Lamp Connector And Glove Box Housing

    Courtesy of KIA MOTORS AMERICA, INC.
11. Install in the reverse order of removal.

    Information 

    • Make sure the connector are connected in properly.
    • Replace any damaged clips.