LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Optima LX 1.6T >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag System Diagnosis (1 Of 2) - Optima (Except HEV) >> DTC B1375-00: Passenger Airbag Active Vent Resistance Circuit To Ground >> Wiring Inspection >> Squib Circuit Inspection

Squib Circuit Inspection

  1. Ignition "OFF".
  2. Disconnect the battery (-) cable and wait at least for one minute.
  3. If dummy and dummy adaptor are not able to be prepared, use a known-good Passenger airbag active vent or 2Ω resistor.
    NOTE: If dummy and dummy adaptor are not able to be prepared, use a known-good Passenger airbag #3 or 2Ω resistor.
    WARNING: Lay Removed Passenger airbag Active vent facing upward for unexpected airbag deployment.
  4. Connect (-) terminal cable to battery and Ignition" and wait for 30 seconds or more.
  5. Connect KDS/GDS to Data Link Connector (DLC) and clear DTC with KDS/GDS and diagnose again.
  6. Are any DTCs stored in the system?

    YES 

    NO 

    • Carefully re-do this troubleshooting guide steps.
    • If problem still occurs, replace Passenger airbag Active vent module and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals