Stop lamp switch clearance adjustment: Installation

Hold the brake pedal arm and insert the stop lamp switch fully.

Fig 1: Inserting Stop Lamp Switch
Courtesy of KIA MOTORS AMERICA, INC.
After inserting, turn the stop lamp switch 45° clockwise; then, finish to assemble it by pushing the locking plate.
Check the gap between stop lamp switch and bracket.
Stop lamp clearance: 1.0 ~ 2.0 mm (0.04 ~ 0.08 in.)

Fig 2: Checking Gap Between Stop Lamp Switch And Bracket
Courtesy of KIA MOTORS AMERICA, INC.

NOTE: If the gap between stop lamp switch and bracket is not 1.0 ~ 2.0mm(0.04~ 0.08in), perform above procedure again.
Connect the stop lamp switch connector.
Following installation is the reverse of removal.