Outside Handle Replacement

Remove the front door trim.
Remove the front door module.
Remove the hole plug (B).
After loosening the mounting bolt, then remove the outside handle cover (A).
Tightening torque:

0.7 ~ 0.5 N.m (0.07 ~ 0.1 kgf.m, 1.0 ~ 0.7 lb-ft)

Fig 1: Removing Outside Handle Cover
Courtesy of KIA MOTORS AMERICA, INC.
Remove the outside handle (A) by sliding it rearward.

Fig 2: Removing Sliding Outside Handle Rearward
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the outside handle connector (A).

Fig 3: Locating Outside Handle Connector
Courtesy of KIA MOTORS AMERICA, INC.
Installation is the reverse of removal.
NOTE:
- Make sure the door locks/unlocks and opens/closes properly.
- Make sure the door locks and opens properly.