Front Seat Outer Shield Cover

CAUTION:

When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts your hands.
Put on gloves to protect your hands.

Remove the recliner switch (A) and height switch (B).

Fig 1: Removing Front Seat Recliner And Height Switch
Courtesy of KIA MOTORS AMERICA, INC.
Using a screwdriver or remover, remove the front seat outer shield cover (A).

Fig 2: Removing Front Seat Outer Shield Cover Using Screwdriver
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the connector (A).

Fig 3: Disconnecting Connector
Courtesy of KIA MOTORS AMERICA, INC.
Installation is the reverse of removal.
NOTE:
- Replace any damaged clips.
- Make sure the connector is plugged in properly.
- Be sure to perform PODS re-zero with the GDS after replacing parts (Passenger's).
  (Refer to appropriate repair procedures.)