LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Optima EX >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Electric Parking Brake Diagnosis - Optima (Except HEV) >> DTC C1612-08: CAN Time-Out TCM >> Wiring Inspection >> CAN Communication Line Inspection

CAN Communication Line Inspection

  1. Ignition switch "OFF"
  2. Disconnect battery (-) cable.
  3. Refer to "ABS CONTROL UNIT and DCT CONTROL MODULE (TCM) (1.6L) or ENGINE CONTROL MODULE (ECM) (2.0L/2.4L) " and disconnect HECU and TCM/PCM connector.
  4. Measure the resistance between Pin No. 44 (C-CAN High) terminal of HECU harness connector and Pin No. 44 (C-CAN High) terminal of TCM harness connector. (1.6 T-GDI)
  5. Measure the resistance between Pin No. 45 (C-CAN Low) terminal of HECU harness connector and Pin No. 45 (C-CAN Low) terminal of TCM harness connector. (1.6 T-GDI)
  6. Measure the resistance between Pin No. 44 (C-CAN High) terminal of HECU harness connector and Pin No. 77 (C-CAN High) terminal of PCM harness connector. (2.4 GDI, 2.0 T-GDI)
  7. Measure the resistance between Pin No. 45 (C-CAN Low) terminal of HECU harness connector and Pin No. 60 (C-CAN Low) terminal of PCM harness connector. (2.4 GDI, 2.0 T-GDI)

    Specification:  Approx. below 1 Ω

  8. Is the measured value within specification?

    YES 

    NO 

scientia non olet · About LEMON Manuals