Rear Right Turn Signal Lamp Circuit Inspection

■ Check Open In Harness 

1. IG "OFF", disconnect battery (-) terminal.
2. Disconnect SJB connector.
3. Measure resistance between the Rear Right turn signal lamp terminal of SJB harness connector and ground of the Rear Right turn signal lamp.

   Specification:  Approx. 1 Ω

4. Is the measured resistance within specification?

   YES 

   • Substitute with a known - good SJB and check for proper operation.

   If the problem is corrected, replace the SJB and go to "Verification Of Vehicle Repair " procedure.

   NO 

   • Repair short to ground in circuit of Rear Right Turn Signal Lamp, and go to "Verification Of Vehicle Repair " procedure.