Rear Left Turn Signal Lamp Circuit Inspection

■ Check Short To Ground In Harness 

1. IG "OFF", disconnect battery (-) terminal.
2. Disconnect SJB, Rear Left Turn Signal Lamp connector.
3. Measure resistance between the Rear Left turn signal lamp terminal of SJB harness connector and chassis ground.

   Specification:  infinity

4. Is the measured resistance within specification?

   YES 

   • Substitute with a known - good SJB and check for proper operation.

   If the problem is corrected, replace the SJB and go to "Verification Of Vehicle Repair " procedure.

   NO 

   • Repair short to ground in circuit of Rear Left Turn Signal Lamp, and go to "Verification Of Vehicle Repair " procedure.