LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Cadenza Base >> Repair and Diagnosis >> Accessories & Equipment >> Steering Column Switches >> MULTIFUNCTION Switch >> Repair procedures >> Removal

Repair procedures: Removal

  1. Remove the steering column upper and lower shrouds after removing 3 screws.
    Fig 1: Removing Steering Column Upper And Lower Shrouds Screws
    G11785433Courtesy of KIA MOTORS AMERICA, INC.
  2. Disconnect the lighting switch connector (A) and wiper & washer switch connector (B).
    Fig 2: Disconnecting Lighting Switch Connector
    G11785434Courtesy of KIA MOTORS AMERICA, INC.
    Fig 3: Disconnecting Wiper & Washer Switch Connector
    G11785435Courtesy of KIA MOTORS AMERICA, INC.
  3. If necessary of removing the wiper & washer switch (A), release the lock of wiper switch using tool without removing the steering wheel and the clock spring.
    Fig 4: Removing Wiper & Washer Switch
    G11785436Courtesy of KIA MOTORS AMERICA, INC.
    NOTE: When removing the wiper & washer switch only, release the lock of wiper switch without removing the steering wheel.
  4. Remove the steering wheel.

    (Refer to Steering System - "STEERING COLUMN & SHAFT ")

  5. Remove the clock spring.

    (Refer to Restraint - "AIRBAG MODULE ")

  6. Remove the multifunction switch assembly (A) after loosening the mounting screws (2EA).
Fig 5: Removing Multifunction Switch Assembly Mounting Screws
G11785437Courtesy of KIA MOTORS AMERICA, INC.