LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Cadenza Base >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Interior Trim & Glass >> Roof Trim >> Repair Procedures >> Replacement >> Roof Trim Replacement

Roof Trim Replacement

NOTE:
  • Put on gloves to protect your hands.
  • When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
  • Take care not to bend or scratch the trim and panels.
  1. Remove the following items:
  2. Remove the ECM mirror cover (A).
  3. Disconnect the ECM mirror connector (B).
    Fig 1: Removing ECM Mirror Cover
    G11785210Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the auto defog sensor & rain sensor cover (A).
    Fig 2: Locating Auto Defog Sensor & Rain Sensor Cover
    G11785211Courtesy of KIA MOTORS AMERICA, INC.
  5. Disconnect the auto defog sensor connector (A) and rain sensor connector (B).
    Fig 3: Locating Auto Defog Sensor Connector And Rain Sensor Connector
    G11785212Courtesy of KIA MOTORS AMERICA, INC.
  6. Remove the LDWS cover (A).
    Fig 4: Locating LDWS Cover
    G11785213Courtesy of KIA MOTORS AMERICA, INC.
  7. Disconnect the LDWS connector (A).
    Fig 5: Locating LDWS Connector
    G11785214Courtesy of KIA MOTORS AMERICA, INC.
  8. Disconnect the roof trim main connectors (A).

    [Driver's] 

    Fig 6: Roof Trim Main Connectors (Driver'S)
    G11785215Courtesy of KIA MOTORS AMERICA, INC.

    [Passenger's] 

    Fig 7: Roof Trim Main Connectors (Passenger'S)
    G11785216Courtesy of KIA MOTORS AMERICA, INC.
  9. Disconnect the antenna connector (A).

    [LH] 

    Fig 8: Locating LH Antenna Connector
    G11785217Courtesy of KIA MOTORS AMERICA, INC.

    [RH] 

    Fig 9: Locating RH Antenna Connector
    G11785218Courtesy of KIA MOTORS AMERICA, INC.
  10. Remove the clips and roof trim (A).
    Fig 10: Locating Roof Trim
    G11785219Courtesy of KIA MOTORS AMERICA, INC.
  11. Installation is the reverse of removal.
    NOTE:
    • Replace any damage clips.
    • Make sure the connector is plugged in properly.