Glove Box Housing Replacement

NOTE:

When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.

Using a screwdriver or remover, remove the crash pad side cover (A).
[RH]

Fig 1: Locating Crash Pad Side Cover (RH)
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the stopper (B) from the glove box (A).

Fig 2: Disconnecting Stopper From Glove Box
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the air damper (A) from the glove box (B).

Fig 3: Locating Air Damper And Glove Box
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the pins (A) and then remove the glove box (B).

Fig 4: Disconnecting Glove Box Pins
Courtesy of KIA MOTORS AMERICA, INC.
After loosening the mounting screws, then remove the crash pad under cover [RH] (A).

Fig 5: Locating Crash Pad Under Cover With Mounting Screws (RH)
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the under lamp connector (A).

Fig 6: Locating Under Lamp Connector
Courtesy of KIA MOTORS AMERICA, INC.
After loosening the mounting screws, then remove the glove box housing (A).

Fig 7: Locating Glove Box Housing With Mounting Screws
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the trunk lock switch connector (A) and glove box lamp connector (B).

Fig 8: Locating Trunk Lock Switch Connector And Glove Box Lamp Connector
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the glove box switch connector (A).

Fig 9: Locating Glove Box Switch Connector
Courtesy of KIA MOTORS AMERICA, INC.
Installation is the reverse of removal.
NOTE:
- Make sure the connector are connected in properly.
- Replace any damage clips.