Signal circuit inspection

■ Open or Short Check 

1. Ignition "OFF".
2. Disconnect HECU and EPS connector.
3. Measure resistance between CAN HIGH (LOW) terminal of the HECU harness connector and CAN HIGH (LOW) terminal of the EPS harness connector.

   Specification:  Approx. below 1Ω

4. Is the measured value within specification?

   YES 

   • Go to "COMPONENT INSPECTION " procedure.

   NO 

   • Repair open in CAN BUS line between HECU harness connector and EPS ECU harness connector and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.