Package Tray Trim Replacement

NOTE:

Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Take care not to bend or scratch the trim and panels.

Remove the rear seat assembly.
(Refer to "REAR SEAT ")
Remove the trunk trim.
(Refer to "TRUNK TRIM ")
After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).
Tightening torque:

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

Fig 1: Locating Rear Seat Belt Lower Anchor With Mounting Bolt
Courtesy of KIA MOTORS AMERICA, INC.
After loosening the mounting bolt, then remove the rear center seat belt lower anchor (A).
Tightening torque:

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

Fig 2: Locating Rear Center Seat Belt Lower Anchor With Mounting Bolt
Courtesy of KIA MOTORS AMERICA, INC.
After loosening the mounting bolt, then remove the rear pillar trim (A).

Fig 3: Locating Rear Pillar Trim With Mounting Bolt
Courtesy of KIA MOTORS AMERICA, INC.
Loosen the trunk inner mounting nuts.

Fig 4: Trunk Inner Mounting Nuts
Courtesy of KIA MOTORS AMERICA, INC.
After loosening the mounting screws, then remove the package tray trim (A).

Fig 5: Locating Package Tray Trim With Mounting Screws
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the connector (A).

Fig 6: Locating Package Tray Trim Connector
Courtesy of KIA MOTORS AMERICA, INC.
Installation is the reverse of removal.
NOTE:
- Replace any damage clips.
- Make sure the connector is connected properly.