LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Cadenza Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Blind Spot Detection System Diagnosis >> DTC C1616-88: CAN bus OFF (C-CAN) >> Wiring Inspection >> CAN communication line inspection >> Check Short To Ground In CAN Communication Line

Check Short To Ground In CAN Communication Line

  1. IG KEY OFF.
  2. Disconnect ECM/PCM, EPS (MDPS), and BSD ECU connector.
  3. Measure resistance between CAN high terminal of diagnostic connector and chassis ground.
  4. Measure resistance between CAN low terminal of diagnostic connector and chassis ground.

    Specification:  ∞ Ω

  5. Is the measured value within specification?

    YES 

    • Check BSD ECU (RH) connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
    • Check short to battery in communication line. And then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals