LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Cadenza Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Smart Cruise Control System Diagnosis >> DTC C1211: Wheel Speed Sensor Rear-RH Invalid/No Signal >> Wiring Inspection >> Terminal and Connector inspection

Terminal and Connector inspection

  1. Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
  2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
  3. Has a problem been found?

    YES 

    NO 

    • The main cause of this code is that there is no WSS signal or improper WSS signal is detected.
    • Check DTCs in ESC system. If there is a code related to WSS, Repair WSS according to DTC diagnostic guide of ESC system.
scientia non olet · About LEMON Manuals