LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Cadenza Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Blind Spot Detection System Diagnosis >> DTC C1616-88: CAN bus OFF (C-CAN) >> Wiring Inspection >> CAN Register And Communication Line Inspection 1

CAN Register And Communication Line Inspection 1

  1. IG Key "OFF".
  2. Connect ECM/PCM, ESP, EPS, BSD connector.
  3. Measure resistance between terminal 3 and 11 of diagnostic connector.

    Specification:  About 60 Ω

  4. Is the measured resistance within specification?

    YES 

    • Check BSD (RH) connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • If the measured value is lower than 10Ω, repair or replace CAN High and CAN Low are short each other. And then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.
    • If the measured value is ∞ Ω, repair or replace the open in CAN High/CAN Low circuit. And then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals