Repair Procedures: Replacement
CAUTION:
- Put on gloves to protect your hands.
NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
- Take care not to bend or scratch the trim and panels.
- Remove the floor console assembly.
(Refer to "FLOOR CONSOLE ASSEMBLY ")
- Remove the crash pad lower panel.
(Refer to "CRASH PAD LOWER PANEL ")
- Remove the glove box housing.
(Refer to "GLOVE BOX HOUSING ")
- After loosening the mounting screws, then remove the crash pad center lower panel (A) by using a screw driver.
- Install in the reverse order of removal.
Information
- Make sure the connector are connected in properly.
- Replace any damaged clips.