Package Tray Trim Replacement

CAUTION:

Put on gloves to protect your hands.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.

Remove the rear seat assembly.
Refer to REAR SEAT .
Remove the rear seat side back assembly.
Refer to REAR SEAT .
After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).
Tightening Torque:

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

Fig 1: Rear Seat Belt Lower Anchor
Courtesy of KIA MOTORS AMERICA, INC.
After loosening the mounting bolt, then remove the rear center seat belt lower anchor (A).

Tightening Torque:

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

Using a screwdriver or remover, remove the rear pillar trim (A).

Fig 2: Rear Pillar Trim
Courtesy of KIA MOTORS AMERICA, INC.
After loosening the mounting screws, then remove the partition lower trim (A).

[Rear Seat 6:4 Type]

Fig 3: Partition Lower Trim (A).

Courtesy of KIA MOTORS AMERICA, INC.

Fig 4: Rear Pillar Trim Connector

Courtesy of KIA MOTORS AMERICA, INC.

Fig 5: Package Tray Trim & Rear Seat Belt Cover

Courtesy of KIA MOTORS AMERICA, INC.

NOTE: