Seat Back Board Replacement

Remove front seat assembly.
Push the lock pin (B), remove the headrest (A).

Fig 1: Lock Pin & Headrest
Courtesy of KIA MOTORS AMERICA, INC.
Remove the protector (A).

Fig 2: Locating Protector
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the connectors (A).

Fig 3: Seat Back Connectors
Courtesy of KIA MOTORS AMERICA, INC.
Push the clips (B) from the seat back board (A).
CAUTION:
- Push the middle area of clip using the flat head screwdriver.
- Be careful not to damage the clip.
  
  Fig 4: Clips & Seat Back Board
  Courtesy of KIA MOTORS AMERICA, INC.
Push the hooks (B), loosen the air ventilation seat duct (A) mounting screws.

Fig 5: Air Ventilation Seat Duct & Hooks
Courtesy of KIA MOTORS AMERICA, INC.
Push the protector (A) by the seat back frame.

Fig 6: Seat Back Frame Protector
Courtesy of KIA MOTORS AMERICA, INC.
Pull out the headrest guides (A) while pinching the end of the guides, and remove them.

Fig 7: Pulling Out Headrest Guides
Courtesy of KIA MOTORS AMERICA, INC.
Remove the seat back cover (A) from the frame.

Fig 8: Seat Back Cover
Courtesy of KIA MOTORS AMERICA, INC.
After removing the hog-ring clips (B) on the front of seat back and remove the seat back cover (A).
CAUTION:
- When removing the hog-ring clip, remove the hog-ring clip with pressing the wire not to separate the wire from the sponge.
  
  Fig 9: Hog-Ring Clips & Seat Back Cover
  Courtesy of KIA MOTORS AMERICA, INC.
Installation is the reverse of removal.
NOTE:
- To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the hog-ring clips (A).
- Replace the hog-ring clips with new ones using special tool (C) (09880-4F000).
  
  Fig 10: Replacing Hog-Ring Clips Cover With SST
  Courtesy of KIA MOTORS AMERICA, INC.
NOTE:
- Be sure to perform PODS re-zero with the GDS after replacing parts (Passenger's).