DTC Information: DTC Detecting Condition

Item	Detecting Condition	Possible Cause
DTC Strategy	Internal Monitoring	EPB ECU
Enable condition	Ignition "ON"
Threshold value	EPB ECU internal hardware error (EEPROM, RAM, ROM, interrupt, timer, A/D converter, cycle time) Current sensor voltage is either higher than 4.7V or lower than 0.1V for more than 200 msec. Current value is 2A for more than 200 msec after 5 seconds upon complete control CAN Hardware Failure
Warning Indicator Lamp Status	Warning Indicator Lamp "ON" EPB status lamp ON: EPB switch "ON" and hold both of wheels OFF: EPB switch "OFF" and release both of wheels Illumination : EPB switch "ON" and not fully secure both of wheels
Fail Safe	EPB operation inhibited
Reset Condition	Ignition "OFF" and then "ON"