Repair Procedures: Replacement: Removal

NOTE:

Remove the following items.
- Front pillar trim
  (Refer to - "INTERIOR TRIM ")
- ECM mirror
  (Refer to the "MIRROR ")
- Rain sensor
  (Refer to the "RAIN SENSOR ")
- Windshield wiper arm
  (Refer to the "COWL TOP COVER ")
- Cowl top cover
  (Refer to the "COWL TOP COVER ")
- Windshield glass deicer connector
  (Refer to the "WINDSHIELD DEICER SWITCH ")
Using a screwdriver or remover, remove the windshield side molding (A).

Fig 1: Identifying Windshield Side Molding
Courtesy of KIA MOTORS AMERICA, INC.
Cut out the windshield sealant using the sealant cutting tool (09861-31100).

Fig 2: Cutting Out Windshield Sealant Using Sealant Cutting Tool
Courtesy of KIA MOTORS AMERICA, INC.
NOTE:
- Do not scrape down to the painted surface of the body; damaged paint will interfere with proper bonding.
- Remove the rubber dam and from the body.
- Mask off surrounding surfaces before painting.
Remove the windshield glass (B) carefully using the glass holder (A).

Fig 3: Removing Windshield Glass Using Glass Holder
Courtesy of KIA MOTORS AMERICA, INC.