Seat Assembly Replacement

Remove the seat track mounting cover.
After loosening the seat assembly mounting bolts, remove the seat assembly (A).
Tightening torque:

49.0 ~ 63.7 N.m (5.0 ~ 6.5kgf.m, 36.2~47.0 lb-ft)

Fig 1: Front Seat Assembly
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the power seat (A) and airbag (B) connectors.
[Driver's]

Fig 2: Front Seat Connectors (Driver's)
Courtesy of KIA MOTORS AMERICA, INC.

[Passenger's]

Fig 3: Front Seat Connectors (Passenger's)
Courtesy of KIA MOTORS AMERICA, INC.
Installation is the reverse of removal.
NOTE:
- Be sure to perform PODS re-zero with the GDS after replacing parts (Passenger's).
  CAUTION: SEAT MOUNTING BOLT INSTALLATION PROCEDURE
  
  Set the seat into the most rearward position. Check that each slide is locked, and then tighten the front mounting bolt temporarily.
  
  Set the seat into most forward position. Check that each slide is locked, and then Tighten the rear mounting bolt completely.
  
  Set the seat into the most rearward position. Check the front mounting bolt completely.
  
  Check that the seat operates to and fro smoothy and the locking portion locks properly.