Repair procedures: Replacement: Notes

Rear Bumper Cover Replacement 

1. Remove the trunk trim.

   Refer to TRUNK TRIM .

2. Disconnect the rear bumper main connector (A).
   Fig 1: Identifying Rear Bumper Main Connector

   Courtesy of KIA MOTORS AMERICA, INC.
3. Disconnect the connector (A), and then loosen the rear combination lamp mounting nuts.
   Fig 2: Identifying Rear Combination Lamp Connector

   Courtesy of KIA MOTORS AMERICA, INC.
4. Remove the rear combination lamp (A) by hitting the part (C) with hand in the direction of arrow, because the rear combination lamp is hung on the lock pin (B).
   CAUTION:

   Be careful that the rear combination lamp can be damaged by dropping it.

   Fig 3: Identifying Lock Pin

   Courtesy of KIA MOTORS AMERICA, INC.
   Fig 4: Identifying Rear Combination Lamp

   Courtesy of KIA MOTORS AMERICA, INC.
5. Remove the screw (A) and clip (B) mounted on upper of the rear bumper.
   Fig 5: Identifying Screw & Clip

   Courtesy of KIA MOTORS AMERICA, INC.
6. Loosen the bolts (A) mounted on lower of the rear bumper.
   Fig 6: Identifying Lower Bolts Mounted On The Rear Bumper

   Courtesy of KIA MOTORS AMERICA, INC.
7. Loosen the screws (A) and clip (B) mounted on the rear bumper side.
   NOTE:

   Replace any damaged clips.

   Fig 7: Identifying Screws & Clips Mounted On The Rear Bumper Side

   Courtesy of KIA MOTORS AMERICA, INC.
8. Loosen the bolts (A) in the trunk.
9. Push the lock pins (B) in the direction of arrow.
   Fig 8: Identifying Bolts & Lock Pins

   Courtesy of KIA MOTORS AMERICA, INC.
10. Remove the rear bumper side (A) by pulling it carefully in the direction of arrow.
    CAUTION:

    Be sure not to damage the rear bumper side.

    Fig 9: Identifying Rear Bumper Side

    Courtesy of KIA MOTORS AMERICA, INC.
11. Pull out the rear bumper cover (A) in the direction of arrow.
    Fig 10: Identifying Rear Bumper Cover

    Courtesy of KIA MOTORS AMERICA, INC.
12. Installation is the reverse of removal.
    NOTE:

    • Make sure the connector is plugged in properly.
    • Replace any damaged clips.