LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2013 >> Optima SXL >> Repair and Diagnosis >> Accessories & Equipment >> Mirrors >> Exterior Body Panels - Except HEV >> Trunk Lid >> Repair Procedures >> Replacement >> Trunk Lid Back Panel Replacement

Trunk Lid Back Panel Replacement

CAUTION:
  • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
  • Put on gloves to protect your hands.
  1. Remove the trunk lid trim.
  2. After loosening the mounting nuts, then disconnect the rear combination lamp connector (B).
  3. Remove the rear combination lamp (A).
    Fig 1: Rear Combination Lamp & Connector
    G07380178Courtesy of KIA MOTORS AMERICA, INC.
  4. Loosen the trunk lid back panel (A) mounting nuts.
    Fig 2: Trunk Lid Back Panel
    G07380179Courtesy of KIA MOTORS AMERICA, INC.
  5. Using a screwdriver or remover, remove the trunk lid back panel (A).
    Fig 3: Identifying Trunk Lid Back Panel Clips
    G07380180Courtesy of KIA MOTORS AMERICA, INC.
  6. Installation is the reverse of removal.
NOTE:
  • Replace any damaged clips.
scientia non olet · About LEMON Manuals